4048PHOENIX INERTIA Heavy sale in United States

CHASSIS
The chassis is constructed with W24 x 55 pound I-beam main frame rails. It has a heavy duty impactor mount with both weld in and bolt on wear liners. The chassis also has an integrated grizzly bypass chute to allow finer material to fall through the grizzly section of the feeder and on to the discharge belt and a cross belt magnet and tower for steel removal from the discharge belt. Two 24” stroke hydraulic legs with 12volt pump are used to raise and level the plant for operation. The plant comes equipped with king pin and a heavy duty tandem axle suspension with 11 x 22.5 tires, air brakes, lights, and mud flaps.
FEEDER
The feeder is an Inertia 48” x 16’ vibrating grizzly consisting of heavy channel and plate construction. It has ½” weld in floor and side liners and a 3’ long grizzly bar section with 3” nominal spacing. The feeder uses two Invicta BL 50-57 vibrating motors along with a slight decline in angle to feed the impactor.
HOPPER
The hopper is removable and is 8’ wide x 18’ long, 9 cubic yards non-heaping. It is constructed of 5/8” plate and a feedbox with heavy-duty chain curtain to prevent material blow back from impactor.
IMPACTOR
The impactor is an Inertia 4048 HSI (40” diameter x 48” wide) single rotor impact crusher with sectionalized frame construction of both welded and bolted heavy plate steel. It has replaceable frame liners of HARDOX-400 material with a wear resistant steel rotor and cast replaceable blow bars. The impactor has two adjustable breaker plates lined with HARDOX-400 material to control product graduation and a spring relief system for non-crushable material. It incorporates self-aligning spherical roller bearings and 4 bolt, split pillow blocks which are protected from dust contamination via a non-rupturable labyrinth seal. It has four access doors for internal observation, inspection, maintenance, and repair, and two hydraulic cylinders for opening the impactor hood.
REAR DISCHARGE CONVEYOR
The rear discharge conveyor is 42” x 38’ under crusher mounted. It has 4’ impact slide bed and CEMA “B” five inch idlers. The tail pulley is a 12” wing pulley with 2 15/16” pillow block bearings bolted to 18” telescoping take-ups. The head pulley is a 16” crowned drum pulley with vulcanized rubber lagging and 2 15/16” pillow block bearings. The conveyor is belt driven by a 15hp electric motor and 415 reducer combination. The conveyor belt is a heavy-duty rip stop belt with a flexco belt splice.
POWER/DRIVE
The plant is powered by a 300hp Diesel engine that belt drives the impactor and 125kw 480V-113 amp generator with 8V belts. The generator supplies power to an on-board electrical switch gear with 100 amp disconnect and circuit breakers. The circuit breakers are used to supply power to the (2) Invicta vibrating motors on the feeder and the conveyor motor, with an additional circuit breaker to supply power to an off-board piece of equipment. The belt drive has a fully enclosed guard with two service doors.

Year	2016
Horsepower	300

40X48 chassis mounted Impact crusher, 300HP Diesel engine with 125 KW gen set, 7 yard Hopper

Year	2007
Location	Montgomery, Alabama
Stock Number	H-1029
Hours	8,500
Serial Number	404806421075
Horsepower	300